Packet Tracer -Navigating The IOS

-
Navigating The IOS


Part 1:Establish Basic Connections,Acces the CLI,and the Explore  Help

Step 1:Connect PC1 To S1 using a console cable
Step 2:Estabis terminal session with S1
Step 3: Explore the IOS help




Part 2:EXPLORE EXEC Modes

Step 1: privilaged EXEC mode




Step 2: Enter global Configuration mode



Part 3: Set The Clock
step 1: Use he clock command




Step2: Explore addtional command messages





Hasil Nilai:

Komentar

Posting Komentar

Postingan populer dari blog ini

Packet Tracer - Configuring initial

-
Gambar
Configuring Initial Configure S1 : 1.  Enter privileged EXEC mode by entering the   enable   command: Switch>   enable Switch# 2.  Enter the   show running- config   command. Switch#   show running- config Switch#   configure terminal Switch( config )#   hostname S1 S1( config )#   exit S1# S1#   configure terminal Enter configuration commands, one per line. End with CNTL/Z. S1( config )#   line console 0 S1( config -line)#   password   letmein S1( config -line)#   login S1( config -line)#   exit S1( config )#   exit %SYS-5-CONFIG_I: Configured from console by console S1# S1#   exit Switch con0 is now available Press RETURN to get started. User Access Verification Password: S1> S1>   enable S1#   configure terminal S1( config )#   enable password c1$c0 S1( config )#   exit %SYS-5-CONFIG_I: Conf...
Baca selengkapnya

Packet Tracer - Connect a Router to a LAN

-
Gambar
Connect a Router to a LAN 1. Click a device and then click the   CLI   tab to access the command line directly. The console password is   cisco . The privileged EXEC password is   class . a.        Which command displays the statistics for all interfaces configured on a router? b.       Which command displays the information about the Serial 0/0/0 interface only?      2.   Enter the following commands to address and activate the GigabitEthernet 0/0 interface on   R1 : R1(config)#   interface gigabitethernet 0/0 R1(config-if)#   ip address 192.168.10.1 255.255.255.0 R1(config-if)#   no shutdown %LINK-5-CHANGED: Interface GigabitEthernet0/0, changed state to up %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0/0, changed state to up                      ...
Baca selengkapnya